Wired Zone Controller DWCPXY
10
Fig.3.8.1 Turbo Setting
3.9 E-heater Setting
E-heater (auxiliary electric heating function): In the Heating mode, E-heater can be turned on for
improved efficiency.
Once the wired zone controller or the remote controller enters the Heating mode, this function will
turn on automatically.
Press “Function” in the Heating mode to enter the E-heater setting interface. Then press
“Enter/Cancel” to cancel this function.
Press “Function” to enter the E-heater setting status if the E-heater function is not activated. Then
press “Enter/Cancel: to activate it.
The setting of this function is shown in Fig.3.9.1 below.
Press Function repeatedly until
reaching the Turbo function status.
Press Function repeatedly until reaching
the Turbo function status again.
To Next Page
Loading...
