Wired Zone Controller DWCPXY
8
Fig.3.6.1 Swing Setting
Notes:
①.Access Sleep, Turbo or Blow setting the same as the Swing setting.
②.After the setting has been done, press “Enter/Cancel” to return to the setting status or
quit automatically five seconds later.
3.7 Sleep Setting
Sleep On: Press “Function” in the “On” state of the unit until entering the Sleep setting state. After
that, press “Enter/Cancel” to confirm this setting.
Sleep Off: When the Sleep function is activated, press “Function” to enter the Sleep setting status.
After that, press “Enter/Cancel” to cancel this function.
In the Cooling or Dry mode, the temperature will increase by 1°F after the unit runs under Sleep1
for one hour and 1°F after another hour. After that, the unit will continue to run at this temperature.
In the Heating mode, the temperature will decrease by 1°F after the
unit runs under Sleep 1 for
one hour and 1°F after another hour. After that, the unit will continue to run at this temperature.
Sleep setting is shown in Fig.3.7.1 below.
Press Function repeatedly until
reaching the Swing setting status.
Press Enter/Cancel to activate the
Swing function.
Press Function repeatedly until
reaching the Swing function again.
To Next Page
Loading...
