TECHNICAL GUIDE
SPLIT-SYSTEM
AIR-COOLED
CONDENSING UNITS
MODELS: HA090
208/230/460
VOLT ONLY
208/230/575
VOLT O NLY
036-21338-001-C-0703
FOR DISTRIBUTION USE ONLY - NOT TO BE USED AT POINT OF RETAIL SALE
®
DESCRIPTION
These Sunline 2000 units are completely assembled, piped and wired
at the factory to provide one-piece shipment and rigging. Each unit is
pressurized with a holding charge of refrigerant-22 for storage and/or
shipping.
The compact design, clean styling, low silhouette, and quiet operation
make these condensing units suitable for almost any outdoor location.
On rooftops…because they weigh much less than a single package
unit of similar capacity and are much easier to rig and support. At
ground level…because their ample sub-cooling capacity allows them
to be located 60 feet below the evaporator coil.
All sheet metal parts are constructed of commercial grade (G90) gal-
vanized steel. After fabrication, each part is thoroughly cleaned to
remove any grease or dirt from its surfaces. The external parts are
coated with a powder paint to assure a quality finish for many years.
This UL approved coating system has passed the 750 hour, 20% salt
spray test per ASTM Standard B117.
All models include a 1-year limited warranty on the complete unit. The
compressor carries an additional 4-year warranty.
A complete line of Evaporator Blower units is also offered to meet your
precise capacity and air handling requirements. Refer to Form 036-
21300-001 for more information on this air side equipment.
FEATURES
• Condenser coil constructed of copper tubes and aluminum fins for
durability and long lasting efficient operation.
• Permanently attached base rails with fork-lift slots and lifting
holes. This design allows for 3-way fork-lift access and overhead
rigging.
• Both high and low pressure controls. Since these controls are
self-contained, there are no capillary lines to be damaged.
• Compressor line-break motor protection and crankcase heaters.
• Anti-short cycle timer to protect the compressor.
• A lockout circuit to prevent the unit from cycling on safety control.
• A 24-volt temperature control circuit.
• Low ambient operation to 45
°F accessories for 0°F low ambient
operation are available.
• A filter-drier (shipped in the unit's compressor compartment for
field installation near the evaporator coil).
• Service valves with a back-seating access port for pressure test-
ing the system. Copper stub-outs are factory mounted on the suc-
tion and liquid service valves to simplify the field piping
connections.
• Separate panel for easy access to the control box without affect-
ing air flow across the condenser coil.
• Gauge lines extend out from cabinet to facilitate servicing.
• Packaging suitable for outdoor storage
• Optional coil guard accessory protect coils with a decorative grille.
http://www.rezine.ne
Page 3
To Next Page
Loading...
