Page 17
User Setup
Vacation
Emergency Heat
When the thermostat is programmed for Vacation mode, and it is in the
Program On mode, it will take effect at 12:00 am of the next day. To turn off
Vacation mode, set the number of days to 0.
To initiate the Emergency Heat feature, Press the EMERGCY button. During
Emergency Heat operation the thermostat will turn on the fan and auxiliary
stages of heat when there is a demand for heat. The 1st stage of heating and
all stages of cooling will be unavailable. To exit Emergency Heat, press the
EMERGCY button.
The Emergency Heat function is only
available if your thermostat is set to
control a Heat Pump.
Press the VACATION button to enter Vacation programming. Use the WARMER and
COOLER buttons to choose the number of days desired to run the Vacation feature.
To confirm your settings and advance to the next step, press the VACATION button
again. Choose the desired Vacation Cool setpoint. Press VACATION. Choose the
desired Vacation Heat setpoint. Press VACATION again to return to the main screen.
EMERGCY
VACATION
Accessory
ACCSRY
The ACCSRY button allows the user to view wired and wireless sensors and
“link” these and other wireless devices to the thermostat via an optional RF
module. Press the ACCSRY button to enter the Accessory setup screen.
Press WARMER to view linked and wired accessories. Follow the instructions
included with the wireless accessory to begin linking process. Next, press
COOLER to enter the wireless linking mode. Press MODE to initiate linking.
Press ACCSRY to return to the main screen. NOTE: A wired outdoor sensor’s
temperature reading is updated once every minute; a wireless outdoor sensor’s
temperature reading is updated once every 5 minutes.
The optional RF Module
must be installed to link
and view wireless accessories.
The Vacation feature allows the thermostat to
use temporary, energy saving setpoints without
having to change regular programming.
(This feature not available on all models)
To Next Page
Loading...
