FORM 160.54-M1(503)
167
YORK INTERNATIONAL
____ Enter chiller START/STOP schedule if
required.
USER Screen:
____ Select desired Display language
____ Select desired Display units; EN GLISH or
MET RIC
____ If desired, establish custom USER ID’s and
PASS WORDS (160.54-M1)
COMMS Screen:
If Modem and or Printer is connected to the Microboard
Serial data ports, enter the following pa ram e ters as re-
quired for each de vice connected:
____ Baud rate
____ Number of data bits
____ Number of stop bits
____ Parity
Enter appropriate number for Modem, Print er or ISN
Remote application:
____ Chiller ID (identifi cation)
PRINTER Screen:
If Printer is connected to Microboard serial ports, en ter
the following:
____ Automatic print logging Enable/dis able
____ Automatic printer logging start time
____ Automatic print logging interval
____ Printer type
____ Report type; STATUS, SETPOINTS,
SCHED ULE or SALES ORDER
SALES ORDER Screen:
____ Enter system commissioning date
OPERATIONS Screen:
(160.54-M1)
____ Select desired Control Source (op er at ing
mode); LOCAL, ISN Remote, DIGITAL Remote
or ANALOG Remote
____ Refrigerant Level Control operation En able/
Dis able
____ Hot Gas Bypass Control (optional) Enable/
Disable
____ Edit Regional phone number if necessary
(Flash Memory Card version C.MLM.01.05.xxx
and later)
____ Enter Local phone number (Flash Memory
Card ver sion C.MLM.01.05.xxx and later)
____ Enter Chiller Style/Compressor (Flash Mem-
ory Card version C.MLM.01.07.xxx and later)
____ Enter Flow Sensor type (Flash Memory Card
version C.MLM.01.08.xxx and later).
25
To Next Page
Loading...
Need help?
General