JOHNSON CONTROLS
3
FORM 160.76-O1
ISSUE DATE: 05/22/2019
ASSOCIATED LITERATURE
MANUAL DESCRIPTION FORM NUMBER
Variable Speed Drive – Operation 160.00-O1
Solid State Starter – Operation and Maintenance 160.00-O2
Floor Mounted MV SSS – Operation 160.00-O5
Unit Mounted MV SSS – Operation 160.00-O7
Installation – Unit 160.76-N1
OptiView™ Control Center – Operation Manual 160.76-O2
Wiring Diagram – Field Connections for YK Chiller (Style H, Q3-Q7) with OptiView™ Control Center and
Unit-Mounted SSS or Remote Medium Voltage SSS, Medium Voltage VSD, or Medium Voltage EMS
160.76-PW1
Wiring Diagram – Field Connections for YK Chiller (Style H, Q3-Q7) with OptiView™ Control Center and
Remote Medium Voltage SSS
160.76-PW2
Wiring Diagram – Field Connections for YK Chiller (Style H, Q3-Q7) with OptiView™ Control Center and
Remote Medium Voltage VSD
160.76-PW3
Wiring Diagram – Field Control Modications for YK Chiller (Style H, Q3-Q7, H9, K1 & K2) 160.76-PW4
Wiring Diagram – Model YK (Style H, Q3-Q7) with OptiView™ Control Center and Electro-Mechanical
Starter
160.76-PW5
Wiring Diagram – Model YK (Style H, Q3-Q7) with OptiView™ Control Center and SSS W/Modbus, LV
VSD W/Modbus
160.76-PW6
Wiring Diagram – Field Connections Model YK Chillers (Style H, Q3-Q7) with Low Voltage Variable
Speed Drive
160.76-PW7
CHANGEABILITY OF THIS DOCUMENT
In complying with Johnson Controls’ policy for con-
tinuous product improvement, the information con-
tained in this document is subject to change without
notice. Johnson Controls makes no commitment to
update or provide current information automatically
to the manual or product owner. Updated manuals, if
applicable, can be obtained by contacting the nearest
Johnson Controls Service office or accessing the John-
son Controls QuickLIT website at http://cgproducts.
johnsoncontrols.com.
It is the responsibility of rigging, lifting, and operating/
service personnel to verify the applicability of these
documents to the equipment. If there is any question
regarding the applicability of these documents, rig-
ging, lifting, and operating/service personnel should
verify whether the equipment has been modified and
if current literature is available from the owner of the
equipment prior to performing any work on the chiller.
CHANGE BARS
Revisions made to this document are indicated with a
line along the left or right hand column in the area the
revision was made. These revisions are to technical in-
formation and any other changes in spelling, grammar
or formatting are not included.
To Next Page
Loading...
