Section 9 Logging
YSI 556 MPS YSI Incorporated
Page 76
Figure 9.13 Pick a Site Screen
5. Use the arrow keys to highlight the site of your choice.
NOTE: If the site of your choice is grayed out in the site list,
refer to Section 9.8 Adding Data to Existing Files.
NOTE: Refer to Section 9.5 Editing a Site List if you want to
edit the site list.
6. Press the Enter key to start logging.
NOTE: If the parameter mismatch screen is displayed, refer to
Section 9.8 Adding Data to Existing Files.
7. If a single point is being logged, the header on the run screen
changes momentarily from Menu to Sample logged to
confirm that the point was successfully logged. See Figure
9.11 Sample Logged Screen. Skip to Step 9.
If a continuous stream of points is being logged, the start
logging entry in the run screen changes from Start logging to
Stop logging. See Figure 9.12 Logging Screen.
8. At the end of the logging interval, press Enter to stop
logging.
To Next Page
Loading...
