Yudian AI-526 - The Parameter Table

25
instead of by pressing in basic display status, and only take HIAL and HdAL as field parameter.
The EP paramters and Loc should be set as follows: EP1=HIAL, EP2=HdAL, EP3=At, EP4=nonE, Loc=1
3.2 The Parameter Table
The parameters can be divided to 8 groups including alarm, control, input, output, communication,
system, setpoint and field parameter definition. They are listed as below in sequence:
Code
Name
Description
Setting
Range
H IA L
High limit alarm
Alarm on when PV>HIAL
Alarm off when PV<HIAL-AHYS,
When the value set to Max. will disable this function
Alarm output action can be defined by parameter AOP.
-9990～
+32000
units
LoAL
Low limit alarm
Alarm on when PV<LoAL;
Alarm off when PV>LoAL+AHYS
When the value set to Min. will disable this function
H dA L
Deviation high
alarm
Alarm on when PV-SV>HdAL;
Alarm off when PV-SV<HdAL-AHYS
When the value set to Max. will disable this function