Yudian AI-526 - Operation Description; Parameter Setting; Set Value Setting

20
2.3 Operation Description
2.3.1 Parameter Setting
In basic display status, press and hold for about 2 seconds can access Field Parameter Table. Press
can go to the next parameter; press 、 or can modify a parameter. Press and hold can
return to the previous parameter. Press (don't release) and then press key simultaneously can escape
from the parameter table. The instrument will escape auomatically from the parameter table if no key is pressed within
25 seconds, and the change of the last parameter will not be saved.
In Field Parameter Table, till the last field parameter Loc appears. Setting Loc=808 and then press
can access System Parameter Table.
2.3.2 Set Value Setting
In basal display status, if the parameter lock “Loc” isn't locked, we can set setpoint (SV) by pressing first、
then can press , or to adjust value. Press key to decrease the value, key to increase
the value, and key to move to the digit expected to modify. Keep pressing or , the speed of