yy-electron.inc 13
Phone Line Anti-Cut Monitoring.
This system is programmed with an alarm function to alert you when your phone line is cut or disconnected; this
function must be turn on to be operational. With your system in
programming status(see page 5), enter the number
sequence below into the keypad. In place of the {0 or 1}, press “1
” to turn on this function or “0” to turn off this
function.
The default factory setting is “ 0” ( Off )
,When this function is activated and the alarm system is “armed”,
line interruption is signaled by three siren blasts at ten second intervals, followed by beeping at five second intervals.
When the alarm system is “disarmed”, line interruption is signaled by beeping at ten second intervals.
【 6 2 0/1 # 】
Remote Access to Keypad/Dialer.
You may change your dialer function settings (arm, disarm, monitor) remotely by phone.
The number of times the phone rings before you are connected with the Dialer System can be preset by entering the
number sequence below into your keypad. With your system in
programming status(see page 5), enter the number
below into your keypad. In place of the {00 to 12} enter the number of rings from (01) to (12). Entering (00) turns off the
remote access function.
The default factory setting is “00”(off).
【 5 3 (0 0-12) # 】
Record Message.
To record your outgoing message, while in programming status
(see page 5), press: rec + # and record your
message for a maximum of 10 seconds.
【REC # 】
Play Back.
To play back recorded message, enter the sequence code below, After entering the pound sign (#), pick up the phone
receiver to hear the message.
【REC 】
To Next Page
Loading...
Need help?
General