yy-electron.inc 2
Activating Sensors
Powering Up The Keypad/Control Unit
Plug power cord into keypad unit receptacle labeled “POWER
This keypad/controller has an enhancing security design with the on/off switch on the top of the
keypad/controller unit. To switch the keypad/control on and off, please press the yellow power switch all the way
down with the tip of a pen or pencil.
” and then into AC power outlet.
Special Note On Setting Up Your Alarm System:
We strongly suggest all our customers program the system and activate all sensors first. Installation of the sensors should be
done after programming process is completed.
To best prevent possible interference, please activate one sensor at a time. Please make sure while activating each sensor,
the rest of the sensors are switched off or power off.
It is preferable that the keypad power adapter be plugged into its own outlet and not share an outlet with other devices
which are potential sources of interference.
Please try to program your system in an area with the least possible interference, for example your basement or a room with
concrete walls to avoid interfering signals being accidentally programmed into the system.
The internal rechargeable system drains down during shipping so the first step in setting up is to turn on the keypad power
switch, attach and plug in the keypad power adapter and let the system recharge for 8-10 hours
The YY Alarm
To Next Page
Loading...
Need help?
General