yy-electron.inc 14
Programming Stored Phone Numbers.
To program your dialer with the phone numbers you want called when the alarm is triggered (up to six numbers), enter
the number sequence below into your keypad. In place of the (enter phone number), enter the phone number that you
want called when the alarm is triggered. If your calling location requires a calling prefix (e.g. New York requires you to
dial 1 first), enter the prefix along with your phone number.
If you want to change any stored phone number, re-enter the sequence code for that number and enter the new
number; you do not have to delete the old number as the system will automatically replace it with the new number.
【 41 (Phone Number) # 】
【 42 (Phone Number) # 】
【 43 (Phone Number) # 】
【 44 (Phone Number) # 】
【 45 (Phone Number) # 】
【 46 (Phone Number) # 】
Resetting Your System Functions.
Please press the “# key” and the “power button” (the one on the top of the keypad in Blue color) at the same time.
Hold them for 2-3 seconds until on the keypad/control panel, the “arm”, “away” and “home” all 3 lights are flashing then
let go of “# key” & “power button”. You will see on the keypad/control panel something look like a pair of parenthesis
appears. Then turn the keypad/control panel off (by pressing the little blue power button again).
Once the above step is performed, turn it on. Use the factory default admin password “1234” and just simply
re-program each and every component.
Please try to program your system in an area with the least possible interference, for example your basement or a room with
concrete walls to avoid interfering signals being accidentally programmed into the system.
To Next Page
Loading...
Need help?
General