yy-electron.inc 8
Activating the Motion Detector / Pet Immune Motion Detector
For each motion detector you use choose a number from 01 to 05
(notice: must be 2 digits)(see page 7),
with your system
in
programming status(see page 5), enter the number below into
the keypad/controller. In the place of {01 to 05} enter the number you
have chosen for the sensor. after the pound sign (#), you will need to
physically trigger the motion detector to activate it. On the motion
detector, switch the ON/OFF switch to the on position. Secondly,
physically move the motion detector about in front of an object as the
motion detector warms up; you will hear a
double beep
sound
indicating that it has been activated. Push EXIT to complete the
process, Each motion detector has to be individually activated using this procedure.
【 study (01 to 05) # 】
Program Home Arm Feature for your motion. (this step is to make sure your motion detectors will be disabled when you
home arm the system).
with your system in programming status
(see page 5), enter the number below into the keypad/controller. In the place of {01
to 05} enter the number you have chosen for the motion detector
Activating the Smoke Detector/Gas Detector/Glass Break Detector.
For each smoke detector/gas detector/glass break detector you use, choose a number from 06 to 08 (notice: must be
2 digits). With your system in
programming status
(see page 5), on your keypad enter the number sequence below.
In the place of In the place of {01 to 08}, enter the number you have chosen for the sensor. After entering the pound
sign (#), you will need to physically trigger the smoking/gas detector/glass break detector to activate them. Activation
will be confirmed by a double beeping sound, Push button EXIT to complete the process.
【 study (06 to 08) # 】
To Next Page
Loading...
Need help?
General