Z-EDGE F1 - Using the Car Dash Cam; Recording Videos; Recording Screen

3 Using the Car Dash Cam
3.1 Recording Videos
With an SD card inserted and the device connected to power, when the car
engine is switched on the dash cam will automatically power on and start
recording. When the vehicle engine is switched off, the dash cam will
automatically save the recording and power off within 10 seconds.
Alternatively, short press the 'OK' button (8) to stop/start video recording
manually.
3.2 Recording Screen
-8-
No. Item Description
Resolution Indicates the current video resolution.
Recording
A flashing red dot indicates the Dash cam is
currentlyrecording.
2
1
Motion Detection Motion Detection : On/Off6
GPS
Blue: Searching for GPS signals.
Green: GPS working status.
7
Recording Time
Indicates the current video recording time.3
Loop Recording Loop Recording setting.5
IR Mode
Indicates the IR night vision setting,On/Off/Auto,
press and hold the 'Up' button (3) for 4 seconds to
change the IR mode.
4
1 2 43
5
6
7
13
8
9
11
10 12