-10-
3.6 Motion Detection
With Motion Detection enabled, video recording is automatically started when
movement is detected by the camera lens. After approximately 10 seconds with
no movement detected, video recording is automatically paused.
Enable/disable feature: Feature Set > Motion Detection
WARNING:
Motion Detection requires the dash cam to be powered. For using this
feature whilst the vehicle is parked and the engine is off, you may need to
hardwire the dash cam to your vehicle. Please seek assistance from a
trained mechanic before attempting this installation.
3.7 Vibration Detection
The Vibration Detection feature senses for unusual impacts or collisions
detected by the built-in G-Sensor. It automatically triggers the Emergency
Video Protection.
To Set the sensitivity to automatically trigger these features with smaller or
larger vibrations (feature can also be turned Off): Feature Set > G-Sensor
sensitivity
3.8 Taking a Snapshot
Short press 'Up' button(4) to switch to photo capture mode.
Capture a photo by pressing the 'Up' button.
3.9 Playback Videos & Photos
• If the device is recording, short press the 'OK' button (6) to stop recording.
• Press the 'Down' button (5) to enter Playback Mode.
• Press the 'Up' & ‘Down’ buttons (4 & 5) to select between Normal Video,
Emergency File, and Photo. Press the 'OK' button (6) to confirm.
Press the 'Power/Menu' button (3) to exit.
Press the 'Up' & 'Down' buttons (4 & 5) to select the Previous or Next file.
Press the 'Power/Menu' button to return to the previous menu.
To Next Page
Loading...
Need help?
General
