31
Find more information at www.zaco.eu
English
Place robot on horizontal ground
and start it.
It is detected that robot is not on a flat
surface. Place the robot on a flat surfa-
ce and start it, or perform levelling in APP
and then restart robot.
Put the robot on the ground to start. The wheels are suspended. Please move
to a new position to start.
Remove any obstacle around robot
and try again.
1. Robot may be jammed or trapped.
Remove any barrier around it.
2. Replace the dustbin and filter screen,
and make sure that both are installed in
place.
Make sure that the dustbin is mounted
in place.
Check the dustbin and filter screen, and
make sure that both are installed
in place.
Make sure the clean water tank has
been installed.
Please reinstall the clean water tank
and make sure that it is in place.
Please make sure the dirty water tank
has been installed.
Please reinstall the dirty water tank
and make sure that it is in place.
Please make sure the sewage mesh
has been installed.
Please clean the dirt water sieve and
make sure that the sieve is in place.
The clean water tank is empty.
Please add clean water in time.
Please check and refill the clean
water tank.
The dirty water tank is full.
Please clean it up in time.
Please empty out the water in the
dirty water tank and clean it up regularly.
The dirty water tank is full.
Please clean it up in time.
Please check and clean the tank.
Please move the robot back to
the cleaning station.
The robot cannot locate the position
of the cleaning station. Please put the
robot back to the cleaning station for
charging.
Low battery level. Please charge robot. The robot fails to locate charging sta-
tion. Please manually place robot back to
cleaning station.
Troubleshooting
To Next Page
Loading...
