How to stop rattling sounds in my Zanussi ZDF26004WA?
Rattling or knocking sounds from inside your Zanussi Dishwasher usually indicate that the tableware is not properly arranged in the baskets, make sure that the spray arms can rotate freely.
How to improve washing results with Zanussi Dishwasher?
If you are experiencing poor washing results with your Zanussi Dishwasher, refer to the 'Daily use', 'Hints and tips' sections, and the basket loading leaflet. Consider using more intensive washing programmes. Clean the spray arm jets and filter, referring to the 'Care and Cleaning' section.
What to do if my Zanussi Dishwasher program does not start?
If your Zanussi Dishwasher won't start, ensure that the appliance door is fully closed. Also, if the delay start function is activated, either cancel the setting or wait until the countdown is complete. Additionally, the dishwasher may be undergoing a resin recharge, which typically lasts about 5 minutes.
What to do if the anti-flood device is on in my Zanussi ZDF26004WA Dishwasher?
If the anti-flood device on your Zanussi Dishwasher is activated and the display shows an error, close the water tap and contact an Authorised Service Centre.
Why is my Zanussi Dishwasher leaking from the door?
A small leak from the door of your Zanussi Dishwasher can occur if the appliance is not level. Try loosening or tightening the adjustable feet. Also, the appliance door may not be centered on the tub; adjust the rear foot if applicable.
What to do if the Zanussi ZDF26004WA program does not start?
If the program on your Zanussi Dishwasher doesn't start, make sure the appliance door is fully closed. If a delay start is set, either cancel the setting or wait for the countdown to finish. Also, the appliance may be undergoing a procedure to recharge the resin inside the water softener, which lasts approximately 5 minutes.
What to do if my Zanussi ZDF26004WA does not drain water?
If your Zanussi Dishwasher isn't draining water and the display shows an error, check these items: * Make sure the sink spigot is not clogged. * Ensure the filter in the outlet hose isn't clogged. * Verify that the interior filter system is not clogged. * Confirm the drain hose has no kinks or bends.
What to do if my Zanussi Dishwasher doesn't fill with water?
If your Zanussi Dishwasher isn't filling with water and the display shows an error, try the following: * Ensure the water tap is fully open. * Check that the water supply pressure is adequate; contact your local water authority for information. * Make sure the water tap isn't clogged. * Inspect the filter in the inlet hose for clogs. * Verify the inlet hose has no kinks or bends.
What to do if Zanussi Dishwasher programme does not start?
If your Zanussi Dishwasher programme does not start, ensure that the appliance door is closed properly. If the delay start function is active, either cancel the setting or wait for the countdown to finish. Note that the appliance may be recharging the resin inside the water softener, which takes approximately 5 minutes.
How to activate Zanussi ZDF26004WA Dishwasher?
If you cannot activate your Zanussi Dishwasher, ensure that the mains plug is correctly connected to the mains socket and check the fuse box for any damaged fuses.
General| Type | Freestanding |
|---|---|
| Place Settings | 13 |
| Energy Efficiency Class | A+ |
| Number of Programmes | 5 |
| Delay Start | Yes |
| Dimensions (H x W x D) | 85 x 60 x 60 cm |
| Color | White |
| Half Load Option | Yes |
To Next Page
