Page 26
9.3 STEER ANGLE INDICATOR GAUGE
If a steer angle indicator gauge with Leds is applied then you will also need to perform
the following steps for the gauge to respond correctly:
1) Use SET MIN FB POT on the hand set to memorize the steer angle feedback pot
voltage for maximum Clockwise rotation of the Drive Unit (see 10.8.12).
2) Use SET MAX FB POT on the hand set to memorize the steer angle feedback pot
voltage for maximum Counter-Clockwise rotation of the Drive Unit (see 10.8.13).
3) Use the hand set SET STEER 0-POS (see 10.8.11) to adjust the steer angle
feedback pot for straight steering MDU.The setting may be adjusted up and down in
5mV increments from the 2.5V default voltage. Test the results by driving the truck
forward and reverse with a centered MDU. Watch for straight travel.
To Next Page
Loading...
Need help?
General
