REQUIRED TOOLS
Make use of the following tools while performing replacement procedures:
Torque wrench with 1/4" hex receptacle)
Phillips driver #1 (tip for 1/4" hex receptacle)
Phillips driver #2 (tip for 1/4" hex receptacle)
Allen key socket tip drivers (tip for 1/4" hex receptacle);
sizes: 1/16", 5/64", 3/32", 1/8", 3mm, 4mm
Nut driver, sizes: 7mm, 8mm, 1/4"
Flat Blade screwdriver (small)
needle-nose pliers
pliers for E-ring retainers (12R)
pliers for axial retainers
tweezers
Clutch torque bit (and torque gauge are spare 105902-060)
.005" shim
Loctite 222 thread locker or equivalent
980428-001 Rev. A 9
To Next Page
Loading...
Need help?
General
