Media Loading
Step 13
This step is not normally required. Some of the
exceptions are listed below. If the media has:
•
An irregular or non-square shape,
•
More than one label across,
•
Less than full width black marks, or
•
The media uses index hole or notches (typi
-
cally for tag stock).
See Appendix A, page A-2, for details on media
sensing, media and sensor adjustment range.
980412-001 Rev.A 17
Installation & Operation
Pinch & Hold (1)
Slide while
Holding the Fins,
then Release (2)
Adjust Sensor
Position
Sensor & Marker
Adjustment
Fins
To Next Page
Loading...
