Zebra 2746e - ELP2 Odometer Commands

ELP2 Odometer
Commands
The print odometer data is accessed and con
-
trolled via EPL2 Page Mode programming
commands. The odometer commands are:
•
URH command - Prints or reports via serial
or USB interfaces a print head history report
for up to ten print heads.
•
URL command - Prints or reports via serial
or USB interfaces the current print head or
total print distance of media run on the
printer.
•
URR command - Prints or reports via serial
or USB interfaces a Print Head Life Re
-
minder status report. The report may include
a custom message stored by the oL com-
mand, to be displayed when a reminder is is-
sued (default is PRINTHEAD LIFE
EXCEEDED), the distance needed to acti-
vate print head life reminder (warning) label,
and the frequency of reminder labels after the
reminder is on and in effect.
• oL, oLn and oLy commands - Set and
control the print head life (exceeded) re-
minder label’s parameters and reporting sta-
tus. See the URR command description,
above.
Print Odometer
D-2 980412-001 Rev.A