Communicating with the Printer
Universal Serial Bus (USB) Communications
The printer is a terminal device when using a universal serial bus interface.
You can re fer to the Uni ver sal Se rial Bus Spec i fi ca tion for de tails re gard ing
this in ter face.
Parallel Communications
When using the parallel port, typically there is no setup is required once the
cable is plugged in. If you should encounter any problems, consult the
user’s guide that came with your computer.
Internal ZebraNet® PrintServer II
TM
Communications
You can refer to the ZebraNet® PrintServer II
TM
for Ethernet Networks
Installation and Operation Guide (part number 46716L) for details
regarding this interface.
Serial Communications
Serial communications between the printer and the host computer can be set
by either autobaud synchronization or the ^SC command.
Autobaud
Autobaud synchronization allows the printer to automatically match the
communication parameters of the host computer. To autobaud:
1. Press and hold the feed button until the green status LED flashes once,
twice, and then three times.
2. While the status LED flashes, send a ZPL II format to the printer.
3. When the printer and host are synchronized, the LED changes to solid
green. (No labels will print during autobaud synchronization.)
18 980410-001 Rev. A
To Next Page
