Print Head Replacement - TLP (continued) 980358-590A
7. Slip the left end of the print head spring 4 into the left side of the ribbon carriage; then slide the
right end into the other side. The angle of the "v" fits into the indent on top of the print head
bracket '.
8. Attach the ribbon take-up hub.
9. Attach the wire cover.
10. Clean the print head with the cleaning pen.
Assembling the Printer
Reload media and ribbon. Plug in the power cord, turn on the printer and run the AutoSense
routine to get a dump mode printout.
82 980358-001 Rev. B
To Next Page
Loading...