Zebra CPCL - SPEED Command

Mobile Printer CPCLProgramming Manual P8-13
SPEED Command
This command is used to set the highest motor speed
level. Each printer model is programmed with a minimum
and maximum attainable speed. The SPEED command
selects a speed level within a range of 0 to 5, with 0 the
slowest speed. The maximum speed programmed into
each printer model is attainable only under ideal condi-
tions. The battery or power-supply voltage, stock thick-
ness, print darkness, applicator usage, peeler usage, and
label length are among the factors that could limit the
maximum attainable print speed.
WARNING: By exercising this command the user overrides the factory
programmed speed for the label being printed, which may adversely affect
print quality. If print quality suffers using the current SPEED setting, the
printer speed should be reduced.
Format
{command} {speed level}
where:
{command}: SPEED
{speed level}: A number between 0 and 5, 0 being the
slowest speed.
SPEED Command Example
Input (SPEED.LBL):
! 0 200 200 150 1
SPEED 4
TEXT 5 0 0 20 PRINTS AT SPEED 4
FORM
PRINT