Zebra CPCL - CUT-AT Command

Mobile Printer CPCLProgramming Manual P8-31
CUT-AT Command Example
This example instructs the printer to print a label, perform
a form-feed, cut the label, and retract the stock by 100
dot-lines.
Input (CUTAT.LBL):
! 0 200 200 250 1
CENTER
TEXT 7 0 0 20 CUT-AT EXAMPLE
CUT
CUT-AT 100
FORM
PRINT
CUT-AT Command
This command is used on printers equipped with a
cutter, in conjunction with the CUT or PARTIAL-CUT
commands. This command will instruct the printer to
retract the stock by a specified length. Printers not
equipped with a cutter will ignore this command. This
command should not be used on printers that use a
thermal transfer ribbon.
Format: {command} {length}
Where: {command}:
CUT-AT
{length}: The unit length the
stock should be retracted after
performing a cut or partial cut.