Zebra CPCL - Tearing or Cutting the Paper

P9-14 Mobile Printer CPCLProgramming Manual
Tearing or Cutting the Paper
PRESENT-AT Command
CUT-AT Command
CUT Command
PARTIAL-CUT Command
Remember to add a few extra Carriage Return/Line
Feeds (CR/LF, or Enter) to the end of your receipt. This
will advance the paper enough to allow the receipt to be
torn off without ripping through the last line of text. After
the printer is done advancing the paper, tear the paper
off.
If your printer can move stock bi-directionally, the
PRESENT-AT command will advance the paper enough
to rip off the receipt and not tear through the last line of
text. Then, when the printer starts on the next item, it will
automatically retract the paper before printing to save on
paper. Using PRESENT-AT without an argument will set
the units to advance to the default for that printer.
Use caution when implementing the PRESENT-AT
command with preprinted media. The media may not
reposition itself exactly when it is retracted prior to resum-
ing printing, and the amount of this error is not repeatable
from label to label . A buffer zone of 18 dots is recom-
mended at the beginning and trailing edge of each re-
ceipt if PRESENT-AT is used.
! U1 PRESENT-AT {units to advance after print}
! U1 PRESENT-AT
For printers with a cutter, the CUT-AT command will
advance the paper, cut, then retract back to not waste
paper. Using CUT-AT without any argument will set the
units to advance to the default for that printer.