Zebra CPCL - Bar Codes, Graphics and Lines

Mobile Printer CPCLProgramming Manual P9-15
! U1 CUT-AT {units to advance after print}
! U1 CUT-AT
Alternatively, the printer can simply cut the paper or
partially cut the paper. (Partial cut is useful when the
receipt may fall to the floor when the user doesn’t grab it
immediately.) At the end of the receipt, put in a sufficient
amount of CR/LF characters, then issue the CUT or
PARTIAL-CUT command.
! U1 CUT
! U1 PARTIAL-CUT
These commands are discussed more fully in Section 8
of this manual)
Bar Codes, Graphics and Lines
Bar Codes:
The printer can create any 1-D bar code in line print
mode. The BARCODE command works just like it would
in a label file. See Section 5 of this manual on the BAR-
CODE command for more details.
The BARCODE command is affected by the justification
commands like “! U1 CENTER”. See JUSTIFICATION
Commands in section 8 of the manual for more informa-
tion.
Graphics:
The printer can print PCX formatted graphics files in
line print mode. This is not recommended, however, in
order to keep print times to a minimum. The graphic
should be loaded into the flash file system on the printer
to achieve maximum printing speed. Please see Section
7 of this manual for more information on graphics, lines,
boxes and PCX Commands.
continued on next page