Mobile Printer CPCLProgramming Manual P10-37
<0x11> = Invalid drive type (currently
only the Towitoko CHIPDRIVE micro is
supported)
<0x12> = Invalid operation
<0x16> = Invalid command length in S-
CARD command
S-CARD COMMAND EXAMPLES
This section provides some examples for using the S-
CARD command to communicate with the internal
Smartcard reader from the ‘External Terminal’.
Read card ATR
! U1 S-CARD CT_ATR
Response:
<ACK><0X0D>< 3B E3 00 FF 91 81 71 26 44 00
54 54 54>
Traceability command:
! U1 S-CARD CT_DATA 10 8010000008
Note: When the printer actually sends
this command to the printer, it converts
the command to binary, adds the appro-
priate T=1 header and computes the
overall command checksum. Then the
printer sends this command to the smart
card.
Response:
<ACK><08>< C9 1C 92 AA 66 19 A0 00><90><00>
CT_CLOSE command
! U1 S-CARD CT_CLOSE
To Next Page
Loading...