P10-38 Mobile Printer CPCLProgramming Manual
continued
DENSO BHT COMMANDS
NOTE: All commands in this section are compatible with ACKNAK-IT v
6.1 or greater.
Zebra mobile printers can have an application down-
loaded which will support communications to the Denso
Barcode Handy Terminal (BHT).
The different methods of communications between a BHT
and a Zebra mobile printer are per the table below:
Connection/protocol type Refer to
Cable IR Autoexec.bat File pg. no
Cable w/BHT PROBHT.CBL P10-52
IR w/BHT PROBHT.IR P10-52
Cable w/BHT-IR PROBHTIR.CBL P10-53
IR w/BHT-IR PROBHTIR.IR P10-53
Data is sent to the printer formatted as a BHT .DAT file.
The printer will check for the “.DAT” filename extension.
Since the format of data using this protocol is not always
what the printer requires, there are several modes of
operation that can be set within the printer to specify how
record data fields delivered by the protocol are inter-
preted.
Setting the Data Format
If the default mode (strip trailing spaces then add CR/LF
for each data field) is not desired, any of the operating
modes can be set by loading an AUTOEXEC.BAT com-
mand file into the printer’s flash memory.
Note that any commands intended to modify the BHT
operating modes must be placed between the SRF-
ACCESS and the END-SRF-ACCESS command lines.
To Next Page
Loading...