Mobile Printer CPCLProgramming Manual P2-1
PRINTER COMMANDS
A label file always begins with the “!” character followed by
an “x” offset parameter, “x” and “y” axis resolutions, a label
length and finally a quantity of labels to print. The line con-
taining these parameters is referred to as the Command
Start Line.
A label file always begins with the Command Start Line
and ends with the “PRINT” command. The commands that
build specific labels are placed between these two com-
mands.
A space character is used to delimit each field in a com-
mand line.
Note: Every line in the command session must be terminated with both
carriage-return
and line-feed characters. All Printer Commands must be in
uppercase characters ONLY.
To Next Page
Loading...
