Zebra CPCL - PRINTER Commands

P2-2 Mobile Printer CPCLProgramming Manual
<!> {offset} <200> <200> {height} {qty}
where:
<!>: Use '!' to begin a control session.
{offset}: The horizontal offset for the entire label.
This value causes all fields to be offset
horizontally by the specified number of
UNITS.
<200>: Horizontal resolution (in dots-per-inch).
<200>: Vertical resolution (in dots-per-inch).
{height}: The maximum height of the label.
The maximum label height is calculated by mea-
suring from the bottom of the first black bar (or
label gap) to the top of the next black bar (or label
gap). Then 1/16” [1.5mm] is subtracted from this
distance to obtain the maximum height. (In dots:
subtract 12 dots on 203 d.p.i printers; 18 dots on
306 d.p.i. printers)
PRINTER Commands
Format:
{qty}: Quantity of labels to be printed.
Maximum = 1024.
maximum ht. =
d - .062”
[1.5mm]
1
st
black bar or
gap
2
nd
black bar or
gap
“d”