P10-42 Mobile Printer CPCLProgramming Manual
continued
specified as BHT by an AUTOEXEC.BAT file.
• The baud rate (if the printer uses the default) is set to
9600 BPS
• The Serial Number is set to ON.
• Zebra mobile printers use a ID number of 9. You
should avoid using this ID value for the terminal.
• The Com port is set to OPTICAL.
BHT-IR File Transmission
Assume that a label file CIS.DAT has been loaded into
the BHT. (Refer to pg. _ for details on loading a *.DAT
file.) The steps to transmit this file via IR are as follows:
1. Depress the 1 / PW / SF keys all at once, then
release. The SYSTEM MENU should be displayed. This
menu has 6 options. This power on sequence must be
performed every time to boot to the SYSTEM MENU. A
regular power on (PW key) will boot into the BHT applica-
tion.
2. Select option 3:UPLOAD. Press the ENT key.
The UPLOAD menu should now be displayed. Select
option 1:DRIVE A. Press the ENT key.
Use the arrow keys, F5, and F6, to scroll through the
menu options to the desired file. (CIS.DAT in our ex-
ample) When CIS.DAT is highlighted, press the ENT key.
3. The IR on the BHT should be pointed towards the IR
window on the printer. The transfer of data will power on
the printer if it is not already on. When file transfer is
complete, ** Completed ** is displayed for the user and a
beep sounds. The file will then print. Press the C key to
exit this screen.
4. Continue to press the C key to exit back 1 menu at a
To Next Page
Loading...