Mobile Printer CPCLProgramming Manual P10-43
continued
time (if desired). The SYSTEM MENU is the top-level
menu.
5. After a successful UPLOAD, the CIS.DAT file must
be re-selected again to transfer to the printer.
NOTES: The arrow keys or a numeric keypress can be used to
select a menu option. The arrow keys are F5 through F8. A press of
the ENT key usually needs to accompany the option selection. Hold
down the PW key for 1 – 2 seconds to turn the BHT off, or let it power
down automatically.
Communication errors can occur infrequently during BHT-
IR transmission. If a transmission is unsuccessful, the data.
should be re-sent.
Configuring the BHT for Cable Transmission
The BHT can also be configured for cable communica-
tions with Zebra mobile printers using either the BHT or
the BHT-IR protocol. All parameters that must be set are
found in the BHT Set System Æ Communication menu
option. The following notes apply:
• The protocol type is set to BHT or BHT-IR protocol.
Printer default is BHT-IR
• The SET CONNECTOR menu options:
1. The TRANSMIT SPEED (if the printer uses
the default) is set to 9600 BPS
2. The PARITY BIT is set to NONE
3. The DATA BIT is set to 8 BITS
4. The STOP BIT is set to 1 BIT
5. The Serial Number is set to ON
6. The Horizontal Parity is set to ON
• The COM PORT is set to IFC (on the BHT-5000 set
COM DEFAULT to CONNECTOR)
To Next Page
Loading...