Zebra CPCL - Power Parameters

Mobile Printer CPCLProgramming Manual P14-33
Power Parameters
power.ascii_graph
type: getvar
This parameter refers to the battery status depicted by
ASCII graphics characters.
getvar result The battery graph, represented by ASCII graphics
characters.
Example Description Get current battery status graph.
Syntax ! U1 getvar “power.ascii_graph”
Result
power.dtr_power_off
type: getvar; setvar
This parameter refers to the remote printer power control.
DTR power off is used for power management. When
DTR is enabled the printer can be powered on and off via
the DSR signal. When DTR-power off is enabled, a low to
high transition will cause the printer to turn ON and a high
to low transition will cause the printer to turn OFF. The
printer will stay ON as long as DSR is high unless it
reaches low battery shutdown or receives a command to
shut down.
NOTE: The inactivity time-out is disabled while DSR is active.
getvar result Current DTR power-off setting.
Example Description Get current DTR power-off setting.
Syntax ! U1 getvar “power.dtr_power_off”
Result “on”
setvar choices “on”, “off”
Default “on”
Example Description Enable DTR power-off.
Syntax ! U1 setvar “power.dtr_power_off”
“on”
Result Printer will enable DTR power-off.