P14-40 Mobile Printer CPCLProgramming Manual
ip.dhcp.enable
type: getvar; setvar
This parameter refers to DHCP setting. DHCP must be
set to “off” before setting a static IP address.
NOTE: It is not recommended that BOOTP and DHCP both be enabled at the
same time since this may increase the printer power-up initialization time. If
both BOOTP and DHCP are enabled at the same time, the printer will first try
BOOTP and if it does not receive a response after several seconds, it will then
try DHCP. You should contact your network administrator to determine
whether your network supports either BOOTP or DHCP and enable only the
proper parameter on the printer.
getvar result The printer printer’s DHCP status (on or off)
Example Description This command instructs the printer
to respond with DHCP setting.
Syntax ! U1 getvar “ip.dhcp.enable”
Result “on”
setvar choices “on”, “off”
Default “on”
Example Description This command instructs the printer
to enable DHCP
Syntax ! U1 setvar “ip.dhcp.enable” “off”
Result The printer’s DHCP will be off upon
cycling printer power or issuing the
device.reset
To Next Page
Loading...