Zebra CPCL - ip.dhcp.cid_prefix

Mobile Printer CPCLProgramming Manual P14-41
ip.dhcp.cid_prefix
type: getvar; setvar
This parameter defines the prefix to be prepended to the
DHCP client identifier (option 61) when DHCP is enabled
and “ip.dhcp.cid_type” is set to “0”.
NOTE: This parameter is only applicable if “ip.dhcp.enable” is set to “on”.
getvar result The current client identifier prefix.
Example Description This command instructs the printer
to respond with the client identifier
prefix.
Syntax ! U1 getvar “ip.dhcp.cid_prefix”
Result “”
setvar choices Any text string up to 10 characters in length
Default “”
Example Description Change CID prefix to “ZEB”.
Syntax ! U1 setvar “ip.dhcp.cid_prefix”
“ZEB”
Result The next time the printer sends a
DHCP request, if “ip.dhcp.cid_type”
is “0”, the client identifier sent will
be prefixed with the string “ZEB”.
e.g., if “ip.dhcp.cid_value” is
“PRT001”, the actual client identi-
fier sent will be “ZEBPRT001”.
continued on next page