Zebra CPCL - ip.http.enable; ip.lpd.enable

Mobile Printer CPCLProgramming Manual P14-45
ip.http.enable
type: getvar; setvar
This parameter refers to the HTTP protocol / web sever
setting.
getvar result This will return the HTTP protocol status. (on or
off)
Example Description This command instructs the printer
to respond with the HTTP setting.
Syntax ! U1 getvar “ip.http.enable”
Result “on”
setvar choices “on”, “off”
Default “on”
Example Description This command instructs the printer
to enable the HTTP protocol.
Syntax ! U1 setvar “ip.http.enable” “on”
Result The HTTP protocol will be turned
on upon cycling the power or
issuing the device.reset.
ip.lpd.enable
type: getvar; setvar
This parameter refers to the LPD protocol setting.
LPD communications from the host should be directed to
port 515.
getvar result This will return the LPD protocol status. (on or off)
Example Description This command instructs the printer
to respond with the LPD value.
Syntax ! U1 getvar “ip.lpd.enable”
Result “on”
setvar choices “on”, “off”
Default “on”
Example Description This command instructs the printer
to enable the LPD protocol.
Syntax ! U1 setvar “ip.lpd.enable” “on”
Result The LPD protocol will be turned on
upon cycling the power or issuing
the device.reset.
continued on next page