P14-64 Mobile Printer CPCLProgramming Manual
WLAN Parameters
NOTE: The following “wlan.xxx” parameters cannot be used on Cameo and
Encore series printers. Cameo”N” and Encore “N” series printers must use
the “LAN” comand set detailed in section 12.
Frequency Hopping Spread Spectum (FHSS) Radio
Compatibility.
The following “wlan.xxx” commands currently either do
not support FHSS radios, or have limited support. Refer
to the individual commands for more detail.
WLAN.XXX FHSS COMPATIBILITY
wlan.current_essid : currently not reported
(wlan.essid can be used instead)
wlan.encryption_mode : only 40 bit encryp-
tion supported. 128 bit encryption is not sup-
ported, 40 bits will be used instead.
wlan.kerberos.kdc: not supported.
wlan.kerberos.mode: not supported.
wlan.kerberos.password: not supported.
wlan.kerberos.realm: not supported.
wlan.kerberos.username: not supported.
wlan.leap_mode: not supported.
wlan.leap_password: not supported
wlan.leap_username: not supported
wlan.operating_mode : infrastructure option
only. Ad Hoc is not supported.
wlan.power_save : currently not supported.
Support is under development.
wlan.preamble: not supported.
wlan.tx_power: not supported.
wlan.tx_rate : choices supported are : 1 and
2.
To Next Page
Loading...