P14-72 Mobile Printer CPCLProgramming Manual
wlan.encryption_mode
type: getvar; setvar
This parameter refers to WEP (Wired Equivalent Privacy)
encryption. This parameter enables and disables the
printer’s WEP encryption. When using WEP encryption
make sure that the encryption key matches the wireless
network WEP encryption key.
NOTES: 1. When using encryption, make sure that the encryption key is set
properly. The encryption key and the encryption index should match the en-
cryption key and encryption index of the access point (or the other network
devices when in AD HOC mode). When all settings are changed the printer
must be wlan.kerberos.mode
2. 128 bit encryption is not supported on units with Frequency Hop-
ping Spread Spectrum (FHSS) radios. 40 bit encryption will be used instead.
getvar result Returns the type of encryption that is currently
being used by the printer.
Example Description Instructs the printer to respond with
the encryption value.
Syntax ! U1 getvar
Result “wlan.encryption_mode”
setvar choices “off”, “40-bit”, and “128-bit”
Default “off”
Example Description This command instructs the printer
to turn encryption off.
Syntax ! U1 setvar
“wlan.encryption_mode” “off”
Result Sets the encryption mode to off.
To Next Page
Loading...