Getting Ready to Print
Loading the Media
You can op er ate this printer in three dif fer ent modes: tear- off, peel- off, or
with a cutter.
■
Tear-off mode allows you to tear off each label (or a strip of labels) after
it is printed.
■
In peel-off mode, the backing material is peeled away from the label as it
is printed. After this label is removed, the next one is printed.
■
In cutter mode, the printer automatically cuts the label after it is printed.
Tear-Off Mode
1. Unlatch the top cover by pulling the two green release levers toward
you (refer to Figure 3). Then, lift the top cover to expose the media
compartment.
• 5
To Next Page
Loading...
