Zebra DA402 - Using ZPL II; Adjusting the Print Width; Adjusting the Print Darkness; Adjusting the Print Speed

Using ZPL II
For detailed information about creating labels using ZPL II, refer to the
ZPLIIProgrammingGuideorvisitourwebsiteatwww.zebra.com.
Adjusting the Print Width
Print width must be calibrated when:
n
You are using the printer for the first time.
n
There is a change in the width of the media.
Printwidthmaybesetbywayofthefive-flashsequencein“FeedButton
Modes”(seepage31)orrefertothePrintWidth(^PW)command(consult
your ZPL II Programming Guide).
Adjusting the Print Darkness
The relative darkness setting is controlled by either the six-flash sequence in
“FeedButtonModes”(seepage31)ortheSetDarkness(~SD)ZPLII
command (follow the instructions in the ZPL II Programming Guide).
Adjusting the Print Speed
Printqualityisaffectedbyprintspeedandthemediayouareusing.Only
by experimenting will you find the optimal mix for your application.
If you find that the print speed needs to be adjusted, refer to the Print Rate
(^PR) command in the ZPL II Programming Guide.
23