Zebra DA402 - Label;Tag Specifications

Label/Tag Specifications
42
Label/Tag Width
1” to 4.25” (25.4 mm to 108 mm)
1” to 2.25” (25.4 mm to 57 mm) for tag stock
Label/Tag Length 0.5” to 22” (13 mm to 559 mm) with standard memory
Interlabel Gap
0.08” to 0.16” (2 mm to 4 mm)
0.118” (3 mm) recommended
Label/Tag Thickness
.003” to .007” (.08 mm to .18 mm)
.003” to .0053” (.08 mm to .135 mm) for cutter option
Label
Roll
Size
Max. Outer
Diameter
5” (127 mm)
Inner Core
1” (25.4 mm) or 1.5” (38 mm)
Media
Requirements
ü
Use Zebra-brand direct thermal media that is outside
wound. Media may be reflective (black mark) sensing
or transmissive sensing, die-cut, notched, or
continuous.
ü For die-cut labels, use only full auto dies.
ü Notched media must have a 0.5” (13 mm) wide x
0.094” (2.4 mm) long cutout located in the center of the
roll. The reflective media black marks must be located
in the center of the roll.
Minimum Black Mark Dimensions:
ü
Mark width: 0.5” (13 mm) centered and perpendicular
to the edge of the media.
ü
Mark length: 0.094” (2.4 mm) parallel to the bottom
edge of the media.