Zebra HC100 - Page 23

23
61330M Printhead Assembly Maintenance Kit
Open the Printer
5/8/08 HC100 Maintenance Manual 61311L-001 Rev. A
Open the Printer
1.
2.
Place the printer on the antistatic mat.
3.
4.
See Figure 5. Press the upper cover release buttons located on both sides of the printer.
Figure 5 • Opening the HC100
Caution • Observe proper electrostatic safety precautions when handling
static-sensitive components such as circuit boards and printheads.
Connect yourself to an antistatic device.
Caution • Turn off (O) the printer before performing the following procedure.
Turn off (O) the printer.
1
Upper cover release button (one on each side)
1