27
61330M Printhead Assembly Maintenance Kit
Remove the Printhead Assembly
5/8/08 HC100 Maintenance Manual 61311L-001 Rev. A
3. See Figure 8. Gently remove all of the wires from the cable clips located at the back
outside edges of the printhead assembly.
Figure 8 • Close-Up View of Printhead Assembly
4. Disconnect the right and left printhead cables.
a. Slide a fingernail between the back edge of the socket and the connector to gently pry
each side of the connector out.
b. Grasp the connector and pull it completely out of the socket.
c. Repeat step 4 for the other cable.
5. Disconnect the small green ground wire from the printhead.
6. Remove the printhead assembly and discard.
1
Cable clips (2)
2
Printhead assembly socket and connector (2)
3
Ground wire (green)
1
3
2
2
1
To Next Page
Loading...
