Zebra HC100 - Page 53

53
Routine Maintenance
Cleaning the Smart Card Contacts and the Media Cartridge Sensor Pins
11/15/10 HC100 User Guide 61207L-002 B
5.
6.
Insert the low-power D/C cord into the D/C power connector on the back of the printer.
7. Turn on (I) the printer power.
8. Reinsert the media cartridge.
9. Discard the used swab.
Caution • Use only vertical strokes to clean the media cartridge sensor pins. Using
horizontal strokes could damage the pins.
Clean the media cartridge sensor pins.
a. Using the swab and vertical strokes, clean the gold media cartridge sensor pins,
which are visible at the back of the media cartridge slot.
b. Allow the solution to evaporate.