Advanced User Information
Changing and Restoring Printer Settings
60
61207L-002 B HC100 User Guide 11/15/10
BAUD Set Baud
This setting applies only when the serial port is used. The baud setting of the
printer must match the baud setting of the host computer for accurate
communications to take place. Select the value that matches the one being used
by the host computer.
Default Value: 9600
Selections: 300, 600, 1200, 2400, 4800, 9600, 14400, 19200, 28800, 38400,
57600, 115200
Corresponding ZPL Command: ^SC
Corresponding SGD Command: None
Located on Web Page: Serial Communications Setup
DATA BITS Set Data Bits
This setting applies only when the serial port is used. The data bits of the printer
must match the data bits of the host computer for accurate communications to
take place. Set the data bits to match the setting being used by the host computer.
Default Value: 8BITS
Selections: 7BITS, 8BITS
Corresponding ZPL Command: ^SC
Corresponding SGD Command: None
Located on Web Page: Serial Communications Setup
PARITY Set Parity
This setting applies only when the serial port is used. The parity of the printer
must match the parity of the host computer for accurate communications to take
place. Select the parity that matches the one being used by the host computer.
Default Value: NONE
Selections: EVEN, ODD, NONE
Corresponding ZPL Command: ^SC
Corresponding SGD Command: None
Located on Web Page: Serial Communications Setup
HOST HANDSHAKE Set Host Handshake
This setting applies only when the serial port is used. The handshake protocol of
the printer must match the handshake protocol of the host computer for
communication to take place. Select the handshake protocol that matches the one
being used by the host computer.
Default Value: XON/XOFF
Selections: XON/XOFF, DSR/DTR, RTS/CTS
Corresponding ZPL Command: ^SC
Corresponding SGD Command: None
Located on Web Page: Serial Communications Setup
Table 9 • Printer Parameters (Continued)
Parameter Details
To Next Page
Loading...
