Zebra P330i - Installing the Print Driver Software and Setting Driver Options

Installation and Setup
Installing the Print Driver Software and Setting Driver Options
980459-001 Rev D Zebra P330i & P330m Card Printer User’s Manual 11
Installing the Print Driver Software and Setting Driver
Options
Printing with the P330i or P330m Printer requires the Windows Print Driver and your card
design/issuing software or printer command level programming through the printer interface.
Both models use the same Print Driver.
The printer can be used with any Windows 2000 or Windows XP computer, using the driver
provided on CD with the printer.
This section contains information on the printing of a sample card in color (using the 5-panel
color ribbon YMCKO and the Windows Print Driver).
Installing the Print Driver
To install the Print Driver automatically on all Operating Systems, use the Zebra Install
Wizard.
The Install Wizard will walk you through the appropriate installation steps. The Wizard will:
• Automatically launch when the driver CD is inserted.
• From the main menu of your documentation CD, select your desired language and then
select “DRIVERS” from the subsequent menu. The Install Wizard will walk you through
the appropriate steps.
• Delete previous versions of the driver and clean up any necessary Registry entries. You
must select “Remove” from the install options to remove any previous driver versions.
Note • If updating the printer driver from a previous version, before installing the updated
print driver version, always delete the existing version from your computer.
Note • Ensure that you have administrative privileges to perform this installation, or contact
your IT department.