22 Zebra P330i & P330m Card Printer User’s Manual 980459-001 Rev D
Installation and Setup
Card Output Hopper
Card Output Hopper
The card output hopper is normally extended to receive the printed cards. The printer may be
operated with the card output hopper in its closed position; in this case the cards will not be
collected in the output hopper.
Step 1. Pull the card output hopper out to place it in its functional position.
Step 2. When not using the printer, slide the card output hopper back into its closed position
to protect the printer from dust and protect the output hopper from damage.
Step 3. The output hopper can be completely removed from the printer if necessary by
inserting a thin, blunt object (such as a pencil) up through the hole in the bottom of
the printer enclosure and pressing (up) to release the hopper while simultaneously
pulling the hopper out. To re-install the output hopper, simply slide the output hopper
in until it locks in place.
Note • The output hopper is a very snug fit to prevent it from moving during shipping or
operation; firm force is required to change its position.
To Next Page
Loading...
