Zebra P330i - Printing a Test Card

Installation and Setup
Printing a Test Card
980459-001 Rev D Zebra P330i & P330m Card Printer User’s Manual 25
Printing a Test Card
With ribbon and cards loaded, your printer is ready to print. To check the operation of the
printer, you should print a test card. (Printing a test card does not require that the printer be
connected to your computer or network, but power must be applied.)
Step 1. Set the printer’s power switch (on the back of the printer) to the OFF ( O ) position.
Step 2. While pressing the Printer’s front panel button (next to the LCD display panel),
switch the printer ON (
| ).
Step 3. Hold the panel button until the LCD display panel reads “SELF TEST”.
Step 4. Release the panel button, and the test card will print.
This is an example of the test card:
PRINTER: P330iM
Serial N°: XXXXX
Firmware: XXXXXXX
Head resistance: XXXX
Offset: XXXX-XXXX
EC:XX
Printing counter: XXXXX
300 dpi
PLASTIC CARD PRINTER
TEST CARD