Zebra P430i - Connecting Power

22 P430i User’s Manual 980470-001 Rev. A
Installation and Setup
Connecting Power
Connecting Power
The P430i Printer includes an internal AC power supply that accepts nominal input voltage in the range from
110 to 230 volts at 50 to 60 Hertz. The power source must be grounded.
Depending on specific model number, your P430i Printer will include one or two power cords; use the one that
is appropriate for the AC power source connection at your location. If neither has an appropriate connector, AC
power cords may be purchased locally; make sure it is a three-wire (grounded) cord.
1. Place the Printer’s power switch in the OFF ( O ) position.
2. Depending on your local AC voltage, plug the appropriate power cord into the printer’s power connector
and a grounded AC power source connection.
3. To turn the Printer on, set the Printer’s power switch to the ON ( | ) position.
Caution • If the power cord appears damaged in any way, or if the power cord will not
securely plug into the Printer’s power connector or the AC power source connection,
STOP! Use of a damaged or incorrect power cord could cause equipment damage,
result in an electrical fire, or possibly cause injury.
Power
Connector
Power
Switch